(1)Improve the centrifugal pump suction port to the impeller near the structural design. Increase the flow area; increase the radius of curvature of the inlet section of the impeller cover, reduce the rapid acceleration and decrease of the liquid flow; reduce the thickness of the inlet of the blade, and make the leaf inlet rounded so that it is close to the streamline, Reduce the speed of the blade around the blade and increase the surface of the impeller and the blade surface to reduce the loss of resistance;
(2)Use pre-induction wheel, so that the flow in the pre-induction wheel in advance to work to improve the flow pressure.
(3)Use double suction impeller, so that the flow from the impeller on both sides of the same time into the impeller, the import cross-section doubled, the import flow rate can be reduced by double.
(4)The design of the use of slightly larger positive angle to increase the blade inlet angle, reduce the blade at the entrance of the bend, reduce the blade blockage to increase the import area; improve the working conditions under high flow to reduce Flow loss. But the angle should not be too large, otherwise the impact of efficiency.
(5)Use anti-cavitation materials. Practice shows that the higher the strength, hardness and toughness of the material, the better the chemical stability and the stronger the resistance to cavitation.
